EasyManua.ls Logo

Stratasys F900 - Adjust XYZ Calibration Offsets for Nylon CF and Ultem1010

Stratasys F900
153 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
107
Figure 5-6: Adjust XYZ Calibration Offsets for Software Version 3.31 and Later
ADJUST XYZ CALIBRATION OFFSETS FOR NYLON CF AND
ULTEM1010
Although the procedure for adjusting the XYZ calibration offsets for Nylon CF and ULTEM1010 is
similar to the procedure described in “Adjust XYZ Calibration Offsets” on page 104, a different
calibration job and screen are used as shown in Figure 5-7..
Figure 5-7: Ad
just XYZ Calibration Offsets for Nylon CF and ULTEM1010

Table of Contents

Related product manuals