Stratasys F900 - Liquefier Tips

16
Table 2-1: Material Build Temperatures
MATERIALS COMPATIBILITY
System/Material compatibility can be found in “Tip Compatibility and Selection” on page 17.
LIQUEFIER TIPS
LIQUEFIER TIPS AND SLICE HEIGHTS
Two types of liquefier tips are available. Standard tips are used for all model materials and for Break-Away
Supports (BASS) materials, and soluble tips are used for soluble support materials. When modeling with
materials that use soluble release support material (SR), use either the T12SR20, T12SR30, or T12SR100 tip
for the support material.
• There are 12 tips available: T12, T12SR20, T12SR30, T12SR100, T14, T16, T16A, T20, T20B,
T2
0C, T20D and T40.
• Tips are a replaceable consumable item. To order tips, see “
Consumable Orders” on page 1. To
change tips, see “Changing Tips or Material Type” on page 96.
• Tips must be changed when the material type is changed.
Material
Maximum
Ex
trusion Temp
Maximum
Oven Temp
ABSi 330°C (626°F) 85°C (185°F)
ABS-M30
ABS-M30i
320°C (609°F) 95°C (203°F)
ABS-ESD7 320°C (609°F) 95°C (203°F)
ASA 330°C (626°F) 100°C (212°F)
Nylon 12 355°C (671°F) 120°C (248°F)
Nylon 12CF 330°C (626°F) 120°C (248°F)
Nylon 6 340°C (650°F) 100°C (212°F)
PC-ABS 330°C (626°F) 110°C (239°F)
PC
PC-IS0
365°C (689°F) 145°C (293°F)
ST130 320°C (609°F) 100°C (212°F)
ULTEM 9085 400°C (752°F) 190°C (374°F)
ULTEM 1010 410°C (770°F) 225°C (437°F)
PPSF 415°C (779°F) 225°C (437°F)
All materials use the same canister type. Extrusion and oven
te
mperatures are automatically set by the system.