Stratasys F900 - Page 26

17
TIP COMPATIBILITY AND SELECTION
Table 2-2 lists the materials available for use with the F900 and their corresponding tips.
Table 2-3 lists the slice heights for each model tip.
Table 2-4 provides approximate tip life, based on the amount of material used.
• The system tracks tip use and automatically prompts you, through the Operator Touchscreen,
w
hen a tip should be replaced. Worn tips are prone to clogs and reduce part quality. See
“Materials/Tools Display” on page 45 for more information on viewing tip use status.
• W
hen changing tips, the Tip Wizard will guide you through resetting the tip odometers from the
d
isplay panel.
• If building with ABS-M30 or ABS-M30i, you can use SR-20, SR-30, or SR-35 support material.
•
If using SR-20 material, use T12SR20 tip only (previously called a T12SR tip).
•
If using SR-30 or SR-35 material, use T12SR30 tip only.
•
If using SR-100 material, use T12SR100 tip only.
•
If using SR-110 material, use T12SR100 tip only.
Th
e standard tip is used for Break-Away Supports (BASS) and model material. See “Tip Identification” on
page 21 for more information.
Table 2-2: Available Tips
Model Material Model Tip Support Material Support Tip
ABSi T12, T16, T20 SR-20 T12SR20
ABS-M30
ABS-M30i
T12, T16, T20 SR-20
SR-30, SR-35
T12SR20
T12SR30
ABS-ESD7 T12, T16 SR-30, SR-35 T12SR30
ASA T12, T16, T20
T40
SR-30, SR-35
SR-30
T12SR30
T20B
Nylon 12
Nylon 12CF
T12, T16, T20,
T2
0C
SR-110 T12SR100
Nylon 6 T14, T20 SR-110 T12SR100
PC-ABS T12, T16, T20 SR-20 T12SR20
PC T12, T16, T20 SR-100 T12SR100
PC
PC-ISO
T12 PC_S T12
PC
PC-ISO
T16, T20 PC_S T16
ST130 T20B ST130-S T20
ULTEM 9085 T16, T20 ULT_S T16
ULTEM 1010 T14, T20
T40
U1010S1
U1010S1
T16
T20
PPSF T16 PPSF_S T16
ANT 800NA T20D ANT 8000SU T16
ANT840CN03 T20D ANT 8000SU T16