79
F. Replace Worn Model (or Support) tip.
• The system tracks the amount of material extruded through a tip. You will receive this prompt when
tip performance may start to become compromised. (Tip-life prediction is an estimated value. Many
factors contribute to actual tip-life aside from amount of material extruded. Actual tip-life may differ
from predicted tip-life.)
• Replace the flagged tip.
G. Model / Support Material Incompatibility.
• Model and support materials are not of compatible types.
• Load correct material.
H. Vacuum not present. Check the build sheet
• Vacuum is below minimum for system operation.
• Correct condition - often the result of a poorly positioned build sheet.
I. Continue.
• You can choose to ignore the warning and ‘Continue’ the build, but part build quality will be
unpredictable.
Note: A warning generated from a mis-match of model/support compatibility or
from low vacuum cannot be bypassed.
To Next Page
Loading...
