How to troubleshoot Stryker GoBed II Medical Equipment bed exit system that does not operate properly?
If the Bed Exit system on your Stryker Medical Equipment is not operating properly, verify the load cell cable connections to the scale control board.
What does 'No scale found' mean on my Stryker GoBed II Medical Equipment?
If your Stryker Medical Equipment scale displays 'No scale found', press the ENTER key. If the message persists, contact our Technical Service. If the message disappears, the data displayed is correct and the current procedure can be resumed.
Why isn't the nurse call signal reaching the nurse desk from my Stryker GoBed II Medical Equipment?
If the Nurse call or Bed Exit signal from your Stryker Medical Equipment does not reach the nurse desk, verify the bed has power. Check the connecting cable and the wall outlet. Contact the Technical Service if problem persists.
What does it mean when all lockout LEDs flash on Stryker GoBed II?
The scale is unable to measure the weight due to an electrical problem. Please contact our Technical Service.
General| Weight Capacity | 500 lbs (227 kg) |
|---|---|
| Mattress Length | 80 in (203 cm) |
| Frame Material | Steel |
| Backrest Angle Range | 0-70 degrees |
| Knee Gatch Range | 0-30 degrees |
| Wheel Diameter | 5 in |
| Reverse Trendelenburg Range | 30 degrees |
| Power Source | AC/DC |
| Features | Adjustable height, Trendelenburg positioning |
Explains the meaning of warning, caution, and note symbols used in the manual.
Defines the intended purpose and environment for the GoBed II MedSurg Bed, Model FL28C.
Details the bed's technical characteristics, including load capacity and dimensions.
Specifies the operating and storage conditions for the bed.
Provides essential safety rules for operating and maintaining the bed.
Highlights potential risks like electrical hazards, patient injury, and proper usage.
Outlines the steps for grounding oneself before servicing electronics.
Lists recommended cleaners and cautions for cleaning the bed surfaces.
A comprehensive list of items to inspect annually for bed maintenance.
Details the lubrication schedule and procedure for actuator screws.
Lists typical bed malfunctions and their solutions.
Lists part names and numbers for electrical and electronic components.
Lists part names and numbers for base structural components.
Provides a wiring diagram for the motor control board.
Details the electrical system diagrams for different power supply configurations.
Wiring diagram for the optional scale system.
Explains error codes related to the scale system.
Step-by-step guide to replace the head end siderail assembly.
Procedure for replacing the foot section of the bed.
Instructions for replacing the fowler motor.
Steps for replacing the main control board.
Lists the parts and quantities for the brake system.
Lists the parts and quantities for the lift mechanism.
Details the various pendant control options available for the bed.
Lists parts for the optional monitor tray accessory.
Lists parts for the optional patient helper accessory.
Lists parts for the optional oxygen bottle holder accessory.
Lists parts for the optional bed extender accessory.
Lists parts for the removable and fixed I.V. poles.
Provides guidance on electromagnetic immunity based on IEC 60601 standards.
Recommends distances for RF equipment to prevent interference.
Outlines the terms and conditions of the product's limited warranty.
Details available service contract options for equipment maintenance.
To Next Page