EasyManua.ls Logo

SUNWARD SWE50E - Page 14

SUNWARD SWE50E
240 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
OPERATION & MAINTENANCE MANUAL SWE50E/SWE60E/SWE70E/SWE80E9/SWE100
6
4Machine posture symbol
Caution
Do not start engine when hydraulic
oil tank runs out of oil.
Inspect hydraulic oil level……daily
Park machine on level ground.
Completely retract arm cylinder and extend
bucket cylinder to full length.
Lower bucket down to the ground.
Run engine at low speed for 5 minutes.
Shut down engine, remove the key.
Place pilot control lever to LOCK (up)
position.
Open right side door to check oil level gauge.
Located on hydraulic oil tank, oil level must be
within level marks. Pump oil if level is higher
than MAX mark, refill if level is below MIN
mark.
add oil
Remove upper breather screw cap by rotating
anticlockwise.
Refill oil through strainer. Recheck oil level
gauge.
Fasten cap securely.

Table of Contents

Related product manuals