OPERATION & MAINTENANCE MANUAL SWE50E/SWE60E/SWE70E/SWE80E9/SWE100
4.5.1.4 Check hydraulic level
【Important】
Do not run engine with empty hydraulic
oil tank.
With arm cylinder folded and bucket cylinder
extended to their full stroke, lower bucket to
ground to stop the machine.
Shut auto-idle switch to run engine unloaded
at low speed for 5 minutes.
【Important】
Improper engine shut-down will damage
turbocharger.
Set starting key to OFF position, stop the
engine and remove the key from starting lock.
Set pilot safety lock lever to LOCK position.
Open inspection door (right back door) for
main pump, check fluid level to ensure that
hydraulic oil will be between fluid level scales.
Otherwise Refill if necessary.
Adding oil
Note
There is pressure in hydraulic oil
tank. Release pressure before opening
oil fill cap.
Release pressure, then remove oil fill cap on
top of hydraulic oil tank to fill oil. Recheck
fluid level.
Lock oil fill cap, make sure oil return
cartridge and suspension rod are positioned
properly.
To Next Page
Loading...
