Position enabling selecting the catalogue in the
instrument memory which contains Area catalogues.
Position enabling selecting the catalogue in the
instrument memory which contains Source catalogues.
Position that enables selecting the catalogue in the
instrument memory which contains files with STIPA
measurement results.
Type of STIPA results averaging: Manual or Auto.
Standard according to which STIPA averages will be
performed in the automatic mode: IEC 60268-16x2 or
IEC 60268x3.
Results to be displayed: STI or CIS.
Adjustment of the reference STIPA signal level to the
level of a real voice signal in the tested area.
Screen that enables setting the ambient noise distortions
in the way of sound pressure in the 1/1 octave bands with
central frequencies from 125 to 8000 Hz. This screen is
connected with the STIPA function.
Instrument's function, enabling alarm setting, generation
and alerting. The alarm setting can be done through the
SvanPC++ software. If Alarms were defined the they can
be seen in the instrument's screens. Some terms, used
in the SvanPC++ software, are presented below:
To Next Page
Loading...
Need help?
General
