If the parameter has a numerical value, you can speed up a selection by pressing the â—„ / â–º key and keeping it
pressed by more than 2 seconds. In this case, the parameter value starts changing automatically until you release
the pressed buttons.
You may change the numerical parameter value with a larger step (usually 10) with the â—„ / â–º key pressed
together with <Shift>.
List of options
The option list consists of different options, from which only one may be
selected. The selection of the option is performed in the following way. Highlight
the desired option with the â–² / â–¼ key and then press <ENTER>. This option
becomes active and the list is closed. After re-entering this list again, the last
selected option will be marked.
Matrix of parameters
When a list of parameters consists of more than one column you may change:
• column with the ◄ / ► key
• line in the same column with the ▲ / ▼ key
• value in a selected position with the ◄ / ► key pressed with <Alt>
• all values in the same column with the ▲ / ▼ key pressed with <Shift>
• all values in the same line with the ◄ / ► key pressed with <Shift>.
Complex parameters
For complex parameters, consisting of more than
one value field like Start Hour or Start Date, you
should first select the field and then change the
value of this field in accordance with the help
information on the bottom of the screen.
In all cases the <ENTER> key is used for confirmation of changes and for closing the opened list of parameters.
The list of parameters is closed, ignoring any changes with the <ESC> key.
Information screen
Some screens inform about the state of the instrument, available memory,
standards fulfilled by the instrument, etc. To scroll through the screen, use the
â–² / â–¼ key. To close such a screen, press <ENTER> or <ESC>.
Text editor screen
In the text editor screens, you may edit text
lines (file names, directory name etc.) The text
editor screen is opened with the â—„ / â–º key
when the position with the text parameter is
selected. These screens provide help
information on how to edit text.
The edited text is displayed in the upper line
and the character, which is displayed
inversely may be changed, deleted or a space
may be inserted before it.
• You can select the position of the
character in the edited text with the â—„ / â–º
key.
To Next Page
Loading...
Need help?
General
