(3) Trim Set
Trim Set can be made the trimming start angle, the acceleration speed of main shaft when started, and the length of
backtack during trimming can be set.
①
Trimming Start Angle
It is set to change the main shaft angle, which launches the trimming motor feeding during trimming.
- The default is one degree. The setting range is -5~5, and can be adjusted by the unit of one degree.
②
Main shaft acceleration time (t) setting when turned on
It sets the time taken for the embroidery machine to accelerate from the inching speed to the embroidery speed
when turned on.
- The default is normal. It can be set as Normal (0) or Slow (1).
[Fig.5.9.7-4] [Fig.5.9.7-5]
Embroidery Speed
Inching Speed
Time
start t
To Next Page
Loading...
Need help?
General
