Installation
Logging on to Response Point Administrator 37
• Not contain a name or user name.
• Not be a common word or name.
2.4.2 Setting the DOS-A50 Date and Time
To set the DOS-A50 date and time values, perform the following steps:
1. On the Base Unit tab, click Change Date/Time in the Properties panel.
The Change Date and Time on Base Unit screen displays.
2. Select the required date and time information from the drop-down menus,
specify the time zone, and select automatic daylight saving adjustments if
required. Click OK.
The following warning displays.
3. Click Yes to save the changes.
N
OTE: The DOS-A50 only reboots if the time zone is changed. All other
changes are updated immediately.
4. Verify the new date and time in the summary screen.
To Next Page
Loading...