Installation
Powering Down the DOS-A50 49
2.7 Powering Down the DOS-A50
The DOS-A50 does not provide an on/off power switch like other electrical
appliances, the Reset button is used to shutdown the DOS-A50 cleanly.
To power off the DOS-A50, perform the following steps:
1. Exit any active Administrator and Assistant sessions.
2. Press and hold the Reset button on the DOS-A50 front panel for 5 seconds
and release.
3. The DOS-A50 enters a Standby state and the LCD panel displays
UNPLUG POWER CORD for 15 seconds.
4. During this time, unplug the power cord from the back of the DOS-A50.
Otherwise wait for the system to reboot.
IMPORTANT!
Do not unplug the DOS-A50 unless the LCD displays UNPLUG
POWER CORD. Incorrect power down can damage the DOS-A50.
To Next Page
Loading...