Station Features 174 FlexSet 120S/280S User Guide
Transfer: Broker/Consultation/3-Way Conference Call
Transfer: 3 Way Conference
During a call you can use this feature to add another party to the call, creating a 3-Way Conference call.
1. During the call, press [Xfer] or the
XFER fixed key.
2. Dial the third party dial number.
3. Wait for the third party to answer.
4. Press [Xfr-3W] or [Xfer] to connect all 3 parties. If your COS definition is defined as ALL, then you must press
[Xfr-3W] again to establish the 3-Way call;
or
Press [FrcRls] to release the third party and to return to the original call (same as consultation call).
Other options after 3-Way call is established:
• Press [Xfer] again to release the third party, and continue conversing with the original party.
• Press the lit [Source] soft key to converse privately with the first (Source) party that you connected to. The
third (Destination) party is put on hold while you converse and the [Dest] soft key flashes.
• Press the lit [Dest] soft key to converse privately with the second (Destination) party that you connected to.
The second (Source) party is put on hold while you converse and the [Source] soft key flashes.
• Press the flashing [Dest] or [Source] soft key to switch between the Source and Destination parties.
• Press [Xfr-3W] to reconnect all three parties again.
• Press [FrcRls] to end the call (3-Way or 2-Way).
NOTE: If you do not succeed in establishing a 3-Way call, your Transfer COS definition may be defined as
Transfer Broker or Transfer Consult.
To Next Page
Loading...
