Tadiran Telecom FlexSet 280S - Page 185

Station Features 177 FlexSet 120S/280S User Guide
Turret
To answer a call at the primary FlexSet
• Press SPKR button on the primary FlexSet
or
• Lift the handset of the primary FlexSet
or
• Press a flashing DSS button on the primary FlexSet or on any of the six expansion modules
To answer a call at the partner FlexSet
• Press SPKR button on the partner FlexSet
or
• Lift the handset of the partner FlexSet
or
• Press a flashing DSS button on the partner FlexSet
Operating a primary call from partner expansion modules
You can control a call conducted at a primary keyset using the Hold, Transfer and Toggle Between Calls functions
programmed into buttons on the primary FlexSet and all six expansion modules.
Operating a partner keyset
To control a call initiated at a partner keyset, use buttons of the partner keyset only.
Button Programming
Buttons on the expansion modules attached to the primary FlexSet can be programmed in the same way as buttons on
the FlexSet itself.
Buttons on the expansion modules attached to the partner FlexSet can be programmed with dial numbers, LOOP,
Boss Group lines, Page Queues and Wait Queues.
The three primary expansion modules can only be programmed from the primary phone. The three partner expansion
modules can only be programmed from the partner phone.