During Idle 42 FlexSet 120S/280S User Guide
[Park] Park. When a call is parked at your station, [Park] appears with a bullet to the left. Use this function to
retrieve the call. (page 135)
[V-page] Voice Page is used to call another keyset station. The called keyset station will automatically answer the
voice page, acting in a similar manner to an intercom. (page 132)
[WhspPg] Whisper Page is used to quietly page one party of a two party call. The other party does not hear the
whisper page. (page 181)
[SltMon] Silent Monitor enables an authorized user to monitor any port, station or trunk (except conference),
without warning to the monitored party. (page 164)
[AcctCd] Account Code is used to mark an external call (incoming or outgoing) with an account code, which can
be used for later reference/billing. Used to enter an account code for the current external call. (page 49)
[IdCtrl] Caller ID Control overrides the system defined caller ID defaults when making external calls. Thus, if
your ID is sent by default when calling external numbers, selecting this will block the number, and vice
versa. (page 73)
[WakeUp] Wake Up is used to set, review, or cancel wakeup calls which will ring your FlexSet at a designated
time. More than one wakeup call can be programmed. (page 175)
[aWake] Attendant WakeUp is relevant for Attendant Console only. Press [aWake] to access the attendant
wakeup options. (page 190)
[CnfIns] Conference Inspect allows you to release a conference participant from an ongoing conference. You
may also view the participant list. (page 79)
[GpCall] Group Calls is used to activate Group Call Conference features. (page 94)
[AcdUcd] ACD/UCD Options is used to activate ACD/UCD features for Call Center or Hunt group agents.
(page 51).
[Lock] Phone Lock is used to prevent unauthorized persons from using your phone line. Incoming calls may
still be answered. (page 137)
[Exec] Executive Privilege is used to copy all the COS features from any system station to your telephone, in
order to use features or to dial numbers restricted to the current station. (page 88)
[COS-Sw] COS Switchover is used to change your Class of Service from Primary to Secondary or vice versa.
Different Classes of Service give different dial and feature capabilities to a particular station. (page 80)
To Next Page
Loading...
