6 Using the product
129
Designation Description
[Insert into new
group]
Creates a new alarm group.
[Move to] Move components/channel to another
alarm group.
[Remove from
group]
Removes the components/channel from
the specified alarm group.
[Delete this group]
Deletes the entire alarm group.
[Apply to all] Applies an alarm group to all
components/channels.
Component list List of the available components and their
affiliation to the selected alarm group.
Group alarm
settings
Enter the group name.
System settings
Output of system alarms: alarm
activation for notification when there is
a connection problem, LoBat and power
failure
Alarm conditions: trigger acknowledged
alarms after [min]
Alarm output Saveris Base: settings for
relays, audible signal and light signal.
[Apply entries] Saves the alarm settings of an alarm
group.
Activate/deactivate
all
Activates all available alarm settings.
Creating a new group
1. Right-click on component, then click on [Insert into new
group].
- A new alarm group is created.
2. Overwrite the default names in Group alarm settings.
Move to…
1. Right-click on component, then click on [Move to …].
- A selection of available alarm groups is displayed.
2. Click on required alarm group.
- The component is assigned to the selected alarm group.
To Next Page
