6 Using the product
135
Pos: 152 /TD/Produ kt verwenden/testo Sa veris/04 Alarme konf igurieren/PRO/01 Alar m vorkonfigurier en - 03 Regeln @ 0\mod_118968441 3734_79.docx @ 4863 @ 25 @ 1
6.5.4. Creating alarm rules
Any configuration changes are only transferred to the
probe/base once you have exited the Alarm Management
menu!
You should therefore exit the Alarm Management menu
after editing.
A prerequisite for the creation of the alarm rules is that the base
alarm settings, the probe alarm groups and the recipients of the
alarm messages have been entered.
1. Click on Alarm Management in the navigation area.
- The data area shows the sub-menus Base alarm settings,
Component alarm settings, Channel alarm settings, Alarm
recipients, Alarm rules, Comments for acknowledging
alarms.
2. Click on Alarm Rules.
- A list of the previously created alarm rules is shown in the
display range.
Designation Description
Group
Group for which the alarm rules apply.
Receiver Recipient who is to receive the alarm
message.
Message
Text of the alarm message.
To Next Page
Loading...
Need help?
General
