5 First steps
85
13. Postpone the start of measurement if necessary.
14. Click on [Finish] to end the hardware startup.
- A message about the successful configuration of the hardware
is displayed.
15. Confirm the message by clicking [OK].
- The new hardware is now ready to be used.
Pos: 88 /TD/Erst e Schritte/testo Saver is/Hardware erwei tern/Extender einbind en Transport/Extend er einsetzen Transpor t @ 8\mod_1291277100991_ 79.docx @ 74295 @ 3 @ 1
5.14.6. Integrating a Saveris extender
3
The Saveris extender communicates automatically with all radio
probes in the system that have been assigned to a mobile zone on
the PC and that are within its vicinity (e.g. when the HGV is at the
loading station). The mobile radio probe must not be logged into
any router or converter.
The Saveris extender is used to pass on the collected probe data to
the Saveris base and data from the Saveris base to the Saveris
cockpit unit.
The Saveris extender is designed for both mobile and
stationary data monitoring. The fundamental difference
compared to the converter is the fact that the
3
This component is only permitted for mobile monitoring in countries with a
radio frequency of 868 MHz.
To Next Page
Loading...
Need help?
General
