6 Using the product
132
Designation Description
Activate/deactivate
all
Activates all available alarm settings.
Creating a new group
1. Right-click on component, then click on [Insert into new
group].
- A new alarm group is created.
2. Overwrite the default names in Group alarm settings.
Move to…
1. Right-click on component, then click on [Move to …].
- A selection of available alarm groups is displayed.
2. Click on required alarm group.
- The component is assigned to the selected alarm group.
Remove from group
1. Right-click on component, then click on [Remove from group].
- The component is removed from the assigned alarm group.
Delete group
1. Right-click on component, then click on [Delete this group].
- The assigned alarm group is deleted, all components that were
assigned to this group are now without an alarm group.
Apply to all
1. Right-click on component, then click on [Apply to all].
- The alarm group assigned to this component is applied to all
other components.
Pos: 151 /TD/Produ kt verwenden/testo Sa veris/04 Alarme konf igurieren/PRO/01 Alar m vorkonfigurier en - 02 Empfänger @ 0\mod_118968 4391828_79.doc x @ 4853 @ 25553 @ 1
6.5.3. Creating recipient
Any configuration changes are only transferred to the
probe/base once you have exited the Alarm Management
menu!
You should therefore exit the Alarm Management menu
after editing.
1. Click on Alarm Management in the navigation area.
- The data area shows the sub-menus Base alarm settings,
Component alarm settings, Channel alarm settings, Alarm
recipients, Alarm rules, Comments for acknowledging
alarms.
2. Click on Alarm recipients.
To Next Page
Loading...
