TESTO Saveris User Manual

6 Using the product
155
2. Select the entry for the alarm to be acknowledged.
3. If necessary, enter a Comment in the relevant field for the
alarm or select one from the acknowledgement comments drop-
down list and confirm the alarm with [OK].
> Where a repeat alarm is set up via the alarm configuration after
acknowledgement of an alarm, you can tick the Do not remind
me again checkbox to specifically suppress a repeat alarm for
selected alarms.
- The symbol shows that the alarm has been confirmed and
the comment is transferred to the alarm list in the display area.
Confirmation of the alarm is transmitted to the Saveris base. As
soon as confirmation is received by the Saveris base, the alarm
relay and alarm status stop flashing and the alarm is deleted.
Pos: 180 /TD/Produ kt verwenden/testo Sa veris/07 Beric hte/00 Berichte erstellen P ROF @ 4\mod_1246526201868_ 79.docx @ 45623 @ 2 @ 1
6.8. Creating evaluations
You can print out series of measurements or have reports on the
data created automatically by the software in definable intervals or
manually at the desired period.
Pos: 181 /TD/Produ kt verwenden/testo Sa veris/07 Beric hte/01 Bericht drucken @ 0\ mod_1189522120546_79.doc x @ 4294 @ 2 @ 1
6.8.1. Printing measurement data
Measurement data can be printed in diagram or table form.
1. Select the day or time period in the calendar for which the
report should be created.
- The data for the day or the time period are shown as a diagram
or table, depending on the setting.
> In the Start | View menu, select the
• Diagram command if the table view is activated but the
diagram view should be printed.
• Table command if the diagram view is activated but the
table view should be printed.

TESTO Saveris Specifications

General

Humidity Range	0 to 100 %RH
Measurement Parameters	Temperature, Humidity
Data Transmission	Wireless
Alarm Function	Yes
Resolution	0.1 °C, 0.1 %RH
Radio Frequency	868 MHz, 915 MHz
Data Storage	Internal memory, Cloud
Power Supply	Battery