6 Using the product
157
- The welcome dialogue box for the startup wizard is displayed.
2. Click on [Next >].
- The System status dialogue box is displayed with the tab
General.
3. Switch to the Projects tab.
4. Select the project you want to end and click on [End
measurement].
- A notification is displayed for you to confirm the reset of the
Saveris base to the basic configuration.
5. Select whether the system components should be logged out
from the Saveris base or remain logged on.
- The project is completed in the Saveris software.
Once the measurement has ended, the radio probe
should continue to run for a further two communication
cycles for data synchronisation before another
measurement can be started again.
To start a new project, you must register all components
on the Saveris base again and then restart the
hardware.
To Next Page
Loading...
Need help?
General
