TOHATSU BFT75A - Page 301

9-16
dummyheaddummyhead
STARTING SYSTEM
Apply grease to the sliding surface of the clutch fork [1].
Set the clutch fork in the indicated position of the
overrunning clutch groove [2] as shown.
Install the overrunning clutch [1] assembly on the front
bracket [2].
• Install the overrunning clutch by aligning the bolt
holes [3] on the outer surface of the ring gear with
the bolt holes [4] in the front bracket.
Install the packing [1].
• Install the packing by aligning the bolt holes [2] on
the packing with the bolt holes [3] in the front bracket
[4].
Apply grease to the planetary gears [1], steel ball [2],
and internal gear [3].
Install the planetary gears, steel ball, and internal gear.
[1]
[2]
[1]
[3]
[4]
[2]
[1]
[4]
[2]
[3]
[1]
[2]
[3]