TOHATSU BFT75A - Page 302

9-17
dummyheaddummyhead
STARTING SYSTEM
Install the brush holder [1] onto the armature [2].
Apply grease to the armature shaft.
Install the rear bracket [3].
Apply water resisting sealant (Sumitomo 3M Padding
Sealer #8533 or equivalent) to the seating surface of
each screw [4].
Install and tighten the two screws.
Check the inner wall of the yoke [1] for foreign material.
Install the armature/rear bracket assembly [2] by
aligning the grommet [3] with the cutout [4] in the yoke.
Install the plate [1] and packing [2] on the front bracket
[3].
Install the yoke/rear bracket assembly [4] by aligning
the projection [5] on the yoke with the cutout [6] in the
front bracket.
Apply water resisting sealant (Sumitomo 3M Padding
Sealer #8533 or equivalent) to the seating surface of
each bolt [7].
Install and tighten the two bolts.
[2]
[1]
[3]
[4]
[3]
[4]
[1]
[2]
[2]
[3]
[1]
[6]
[7]
[7]
[5]
[4]