TOHATSU BFT75A - Page 445

16-16
dummyheaddummyhead
GEAR CASE
INSTALLATION
Apply soapy water to the outer circumference of new
water seals [1].
Drive the water seals one by one into the shift rod
holder [2] using the special tool. Note the installation
direction of the water seals.
Be sure to apply marine grease to the water seal mating
surfaces before installation.
After installing the water seals, apply marine grease to
the water seal lips.
Install the E-ring [1], washer [2], and the shift rod spring
[3] on the shift rod [4].
TOOL:
Installer/remover,
14.5 x 18.5 mm [3]
07ZPF-ZW90300
[2]
[3]
[1]
[1]
[4]
[3]
[2]
[1]