TOHATSU BFT75A - Page 446

16-17
dummyheaddummyhead
GEAR CASE
Insert the shift rod [1] into the gear case, aligning the
cam of the shift rod with the "A" point [2] of the gear
case as shown.
Install the shift rod on the shift slider [3], aligning the
cam of the shift rod with the grooves in the shift slider.
Apply marine grease to the circumference of a new O-
ring [1], and install it on the shift rod holder [2].
Install the shift rod holder [1] in the gear case, aligning
the projection [2] of the shift rod holder with the recess
[3] in the gear case.
Install the bolt [4] and washer [5] and tighten the bolt.
After installation, check that the cutout in the shift rod
spline is in the cruising direction (page 16-7).
[2]
[3]
[1]
[1]
[1]
[2]
[1]
[2]
[3]
[4]
[5]