TOHATSU BFT75A - Page 501

18-20
dummyheaddummyhead
TRIM/TILT
Apply marine grease to the circumference of the swivel
case liners [1].
Install the swivel case liners by aligning the projection
[2] on each swivel case liner with the recess [3] in the
swivel case.
Apply marine grease to the circumference of a new oil
seal [1].
Install the oil seal in the bottom of the swivel case using
the special tool. Note the installation direction of the oil
seal.
Apply marine grease to the lip of the oil seal.
[2]
[2]
[1]
[3]
[3]
[1]
TOOL:
Driver [2] 07749-0010000
Attachment, 52 X 55 mm [3] 07746-0010400
[2]
[3]
[1]