TOHATSU BFT75A - Page 502

18-21
dummyheaddummyhead
TRIM/TILT
Apply marine grease to the circumference of the thrust
washer [1] and install it to the mount frame [2].
Apply marine grease to the circumference of the mount
frame shaft and install the mount frame on the swivel
case [3].
• Install the mount frame with care not to push the
swivel case liner out of the swivel case.
Apply marine grease to the wave washer [4] and install
it on the mount frame.
Warm up the lower mount center housing [1] using a
heat gun (ETB1600: commercially available) [2].
• Wear gloves to protect your hands when handling
the lower mount center housing.
Apply marine grease to the spline of the lower mount
center housing.
Set the lower mount center housing to the mount frame
[3] by aligning the " " mark [4] on the lower mount
center housing with the mark [5] on the mount frame
that was made during disassembly.
Drive in the lower mount center housing until it does not
come off using the special tools as shown.
• Drive in the lower mount center housing at right
angles to the swivel shaft.
[1]
[2]
[3]
[4]
TOOLS:
Driver [6] 07749-0010000
Attachment, 52 x 55 mm [7] 07746-0010400
[5]
[4]
[7]
[6]
[1]
[3]
[1]
[2]