TOHATSU BFT75A - Page 562

19-25
dummyheaddummyhead
CONTROLS
Remove the bolt [1] from the connector bracket [2], and remove the harness and the connector bracket as a set
from the tiller handle.
Remove the harness band clip [3], which clamps tube A [4], from the connector bracket.
Remove the warning buzzer [5] from the housing.
Open the harness band clip [1] that clamps the cord
tube (40 mm) [2].
Remove all the connectors [3] from the cord tube (40
mm).
[1]
[2]
[4]
[3]
[5]
[1]
[2]
[3]