Topcon KR-1W - RMS Threshold 2 (6 mm) and RMS Digits; RMS Threshold 2 (6 mm)

58
INDIVIDUAL OPERATIONS
6 When the measuring head comes to the measuring position and alignment is complete, a
message "Press MEASUREMENT switch to start measurement." is displayed.
7 By pressing the , measurement is performed and measure-
ment values are displayed.
• It will take a few seconds for measurement to be fully complete, and display the final
results.
8 After finishing measurements, auto alignment is continued.
If a limit message " " is displayed during auto alignment, indicating that the mea-
suring head has reached the maximum limit of movement, manually operate the
unit, using the control lever, toward the proper direction of alignment. For the limit
message, see page
55.
Auto alignment is not complete while the control lever is in use.
To enable a smooth auto alignment operation, do not utilize the control lever.
After "FINISH" is displayed, it is possible to continue measurement by pressing the
.
To stop the auto alignment, tap and stop the auto alignment. To
resume the auto alignment, tap .
MEASUREMENT switc
h
MEASUREMENT switc
h
MANUAL
AUTO