45
BASIC OPERATIONS
9 When all the set measurements are done, the screen is changed to the Measurement
Result List screen.
DISPLAYING MEASUREMENT VALUES
Data of the latest measurements are displayed on the control panel screen.
Display of measurement values only: Measurement was done correctly.
ERROR: Measurement was not done correctly.
CLEARING ALL MEASUREMENT VALUES
When multiple patients are measured continuously without printing/transferring the measure-
ment data of the previous patient, measurement values of the new patient are saved following
the measurement data of the previous patient.
It is possible to clear any unnecessary data.
Auto print (available only under Auto mode)
When the auto print function is set to "ON" in the initial settings menu, measurements will
automatically print out when the exam is completed.
Note, if the measurement to be performed is set for only the right or left eye (MONO), the
auto print function will not work. For the setting of eyes to be measured, see "
MEASUR-
ING ONE EYE ONLY" on page 52.
It is possible to not automatically move to the position for measuring the other eye after
measuring one eye. For details, see "
MEASURING ONE EYE ONLY" on page 52.
If MONO mode is selected, total measurement is completed after measurement of the
selected eye is performed.
After "FINISH" is displayed, it is possible to continue measurement by pressing the
.
To stop the auto alignment, tap and stop the auto measurement. To
resume the auto measurement, tap .
For messages on the control panel screen, see "MESSAGE LIST" on page 184.
It is possible to display all measurement data on the screen. For details, see "DIS-
PLAYING ALL MEASUREMENT DATA" on page 70.
MEASUREMENT switc
MANUAL
AUTO
To Next Page
Loading...
