183
BEFORE REQUESTING SERVICE
BEFORE REQUESTING SERVICE
CHECKING OPERATIONS
If a problem is suspected, perform checks following the Check List shown below. If the problem
does not improved by the suggested remedy or if it is not described in the list, call your dealer or
TOPCON, printed on the back cover of this manual.
CHECK LIST
WARNING
Do not open the cover. For repair, contact your authorized
Topcon distributor.
Keep the instrument in a dry place.
Problem: Check point: Remedy: Page:
Control panel does not
work.
Power cable is not plugged
into receptacle.
Plug in power cable.
31
Power cable is not plugged
into instrument body.
Plug power cable into
instrument body.
31
Power save status is on.
Return to normal status by
pressing the MEASRE
-
MENT switch on control
lever.
35
Fuse is burned. Replace fuse. 181
Control panel is not clear. The image is dark. Adjust the brightness of
monitor screen by the LCD
brightness control of SET
-
TINGS screen.
138
Auto measurement is not
possible.
Measuring window needs
to be cleaned.
Clean measuring window.
180
Condition of patient's eye
is not good.
Do measurement under
manual mode.
59,63
Manual mode is on Change it to auto mode. 54
Paper comes out unprinted. Printer paper winding is
reversed.
Set printer paper correctly.
33
Paper does not come out. Printer paper is used up. Supply printer paper. 33
Communication is not possi-
ble.
Setting of communication
format is incorrect.
Reset communication
format.
169
Anomaly in control lever and
other movable components
Leave it as is, and call
Topcon service.
-
Main body does not start
correctly.
Leave it as is, and call
Topcon service.
-
Failed in network data trans-
mission.
LAN cable is unplugged. Plug LAN cable. 32
IP address is not set cor-
rectly in LAN connection
setting.
Check and reset LAN con-
nection setting of main body
and connected PC.
171
To Next Page
Loading...
