Topcon KR-1W - Preparations; Installing the Instrument

20
COMPONENTS
CONTROL PANEL COMPONENTS (ANALYSIS RESULT SCREEN)
ANALYSIS RESULT SCREEN
The KR-1W can perform REF/KRT measurements and aberration measurements by capturing
Hartmann Shack and Mire images of the patient's eye. After the measurement, tap the
button to display analysis results on Measurement Result List Screen.
(1) Data feed button (7) If there are too many data to display on the Measurement value
data tab, the tab of the next measurement data is displayed or the
previous measurement value data tab is displayed.
(2) Layout Change button
Displays the measurement result by changing it to the previously set
layout pattern. Four layout types can be registered. (For screen lay
-
out, see page 142)
(3) Patient ID The Patient ID INPUT screen is displayed. The patient ID is dis-
played on the right.
(4) R-L Change button Moves to the first measured data of each of the right and left eyes.
(5) Function button A list of operable functions is displayed. Select a relevant button by
the touch panel.
button The screen returns to the measurement screen for addi-
tional measurements. However, note that the display
changes to start a new measurement when data is out
-
put to the connected PC and printed throught the built-in
printer and the external printer.
button The measurement data currently displayed are cleared.
button
Changes to Result List display mode. (see page 74.)
button Selected measurement result data can be outputted to
the RS-232C or to the connected PC.
button When the external printer is set, the displayed analysis
result can be outputted to the external printer. For
ANALYZE
(5) Function button
(4) R-L Change button
(6) Analysis result
(2) Layout Change button(3) Patient ID
(8) SETTINGS button
(7) Measurement
value data tub
(1) Data Feed button
MEASURE
DELETE
RESULT LIS
T
DATA OUT
PRINT