6
Ensuring the Safety of Patients and Operators
To avoid injury in changing the measurement mode, do not place fingers into the measuring
opening.
To avoid electric shock, do not open cover. For repair, ask a certified Topcon Service Engineer.
When changing the fuse, turn off the power, and disconnect the power cable. Use the properly
rated fuse.
Preventing Electric Shocks and burn.
To avoid injury, when moving the chinrest up/down, keep fingers away from moving parts.
When operating the instrument, be careful not to touch the patient's eye or nose.
Electromagnetic Compatibility (EMC)
This instrument has been tested (with 100/120/230V) and found to comply with IEC60601-1-2:
Ed.3.0: 2007.
This instrument may emit a radio frequency energy (within the standard) and cause an
adverse effect on the devices located nearby.
When such effect is confirmed by the ON/OFF operation, a proper treatment as to change the
direction, use another outlet, etc. is recommended. If the problem remains unsolved, call your
dealer.
CAUTIONS
To Next Page
Loading...
