142
TRK-3 OMNIA SOFTWARE LICENSE TERMS
PLEASE READ THE FOLLOWING “LICENSE TERMS” CAREFULLY BEFORE USING OR INSTALLING THIS
SOFTWARE!
This software includes the “Qt” software licensed by Digia Plc (Head office: Finland).
ANY AND ALL TERMS AND CONDITIONS OF THE “LICENSE TERMS” SHALL BE DEEMED TO BE ACCEPTED
AND AGREED BY YOU IF YOU USE THIS SOFTWARE.
The TRK-3 OMNIA Software, including its instruction manual and other documents, contained in this package com-
prises copyrightable works of TOPCON CORPORATION protected by copyright laws and is licensed, not sold. Digia
Plc and its licenser posses the copyright and the intellectual property right of the “Qt” software installed in TRK-3
OMNIA.
TOPCON CORPORATION grants to you the right to use this TRK-3 OMNIA Software under the terms and condi
-
tions outlined below.
LICENSE TERMS
1. LICENSE
Subject to the terms and conditions outlined in these LICENSE TERMS, TOPCON CORPORATION
(“TOPCON”) hereby grants to you (“USER”) a non-exclusive and non-transferable license (“LICENSE”)
to use the TRK-3 OMNIA SOFTWARE (including the “Qt” software (“Qt”)) including its instruction man
-
ual and other documents (separately or collectively the “SOFTWARE”) only on the TRK-3 OMNIA
instrument you use (“INSTRUMENT”).
2. RESTRICTION
2.1 USER shall NOT:
(a) use the SOFTWARE on or with any computer or instrument other than the INSTRUMENT, or
(b) make any copy of part or whole of the SOFTWARE and distribute the copy; or
(c) disclose this software to the third party; or
(d) sell, assign, exchange, pass, rent, lease or otherwise dispose of the SOFTWARE, or assign or sub-license
any right to use the SOFTWARE to anyone else; or
(e) adapt, modify or alter the SOFTWARE, or merge any program with the SOFTWARE, or make any deriva-
tive or secondary copyrighted work from the SOFTWARE; or
(f) remove, erase or make unclear any copyright notice of the SOFTWARE; or
(g) analyze or make reverse-engineering to, the SOFTWARE by decompiling or disassembling it; or
(h) make a copy of the instruction manual and other documents contained in this package.
3. COPYRIGHT
The SOFTWARE is the exclusive property of TOPCON, and full title, ownership and interests and copyrights
thereof shall remain vested with TOPCON at any and all times. Digia Plc and its licenser posses the copyright
and the intellectual property right of Qt.
4. TERM
These LICENSE TERMS shall commence on the date when the SOFTWARE is first used by USER,
and shall remain in full force until the termination hereof pursuant to the provisions set out in Section
5.1 below.
5. TERMINATION
These LICENSE TERMS shall be forthwith terminated if:
To Next Page
Loading...
