48
BASIC OPERATIONS
BASIC OPERATIONS
PREPARATION BEFORE MEASUREMENT
SETTING THE PHYSICIAN ID
1 Tap the button on the control panel.
2 Tap the button and the physician ID input screen will pop up.
3 Press the Physician ID input window and enter the Physician ID using the input buttons. Press
the
button after entering the ID to complete the entry.
4 Return to the Measurement screen, and confirm that the physician ID is updated.
NOTE
• The Physician ID input field is displayed when “Physician ID” and “Use
Physician ID” are set to ON on the Setup screen.
• If an ID is read using the barcode reader while the physician ID input
screen is displayed, the physician ID input screen closes automatically
after the reading is completed, and the Measurement screen appears.
Physician ID input
Set
Physician ID input window
Capital lock key
Input button
To Next Page
Loading...
