40
BASIC OPERATIONS
BASIC OPERATIONS
PREPARATION BEFORE MEASUREMENT
PREPARATION BEFORE MEASUREMENT
TURNING ON THE INSTRUMENT
1 Plug the power cord into a commercial power source (3-pin AC inlet with grounding).
For the details of the connection, refer to “CONNECTING POWER CORD” on page 31.
2 If connecting external device is required, connect the external device and turn on the device.
3 If the measuring window cap is attached, remove it.
Remove the intraocular pressure measuring window cap while pressing the left and right pro-
trusions from both sides.
4 Press on the POWER switch.
NOTE
• Do not put the patient's chin on the chinrest until the power is on.
• If the POWER switch is turned ON immediately after turning OFF the
POWER switch, it may be unable to restart by the protective function of
power supply. Please turn ON the POWER switch after waiting 3 seconds
or more, when the POWER switch is turned OFF.
NOTE
• When attaching and removing the intraocular pressure measuring window
cap, do not apply any load to the measuring nozzle.
• If strong force is applied to the measuring nozzle, the measuring nozzle
may bend.
To Next Page
Loading...
