17
COMPONENTS
Physician ID input button
......Displays the software keyboard. Enter the ID, name, etc.
Displayed when “Physician ID” and “Use Physician ID” are
set to ON on the Setup screen.
R/L button................................Selects the right/left eye. By tapping the button, the main
body moves to the selected direction. The selected button is
framed in purple. The layout where the R/L button is dis-
played reverses according to the position of the control
panel.
R/K measurement mode selection button
......Selects each measurement REF, KRT.
Up/down button for chinrest.........Moves the chinrest up/down.
End button ...........................................The chinrest and measuring head move to the last position.
Turn off the power when the movement to the last position
has completed.
Measuring head forward/backward button
......Moves the measuring head closer to/away from the patient's
eye. The forward and backward operations reverse accord-
ing to the position of the control panel.
Start button...........................................Starts measurement.
Auto/Manual button.................................Switches between Auto mode and Manual mode.
If “AUTO” is displayed on the control panel it is in Auto mode,
if “MANUAL” is displayed it is in Manual mode.
Mode button..........................................Selects and sets each measurement of REF, KRT, TONO,
and PACHY.
Cataract button....................................If it is difficult to measure due to cataract (lens opacity) or
obstruction of eyelids, eyelashes, blinking, etc., tap this but-
ton to enable cataract mode and adjust the amount of light to
make measurement easier. The CAT icon appears in the
upper part of the control panel, and the button frame changes
to purple.
Fixation target button ....................Brightness of the fixation target can be changed.
To Next Page
Loading...
