EasyManua.ls Logo

Toro Workman HDX Auto - Jacking Vehicle

Toro Workman HDX Auto
280 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Workman HDX Auto
Page 1 − 5
Safety
Jacking Vehicle
When changing attachments, tires or perform-
ing other service, use correct jacks, hoists and
jack stands. Always chock or block the wheels
and use jack stands to support the vehicle. If the
vehicle is not properly supported by jack
stands, the vehicle may move or fall resulting in
personal injury.
WARNING
1. Do not start engine while vehicle is on jack, because
engine vibration or wheel movement could cause ve-
hicle to slip off jack.
2. Do not work under vehicle without jack stands sup-
porting it. The vehicle could slip off jack, injuring any one
beneath it.
3. The jacking point at the front of the vehicle is under
the front center frame support (Fig. 1). When jacking up
front of vehicle, always place a wood block (or similar
material) between jack and vehicle frame support.
4. The jacking point at the rear of the vehicle is under
the axle (Fig. 2).
Figure 1
1. Front jacking point
1
1
Figure 2
1. Rear jacking point
1
1
Safety

Table of Contents

Related product manuals