Workman HDX Auto
Page 3 − 15
Kohler Gasoline Engine
Removal (Fig. 16)
1. Park vehicle on a level surface and engage parking
brake.
2. Raise or remove the cargo bed or other attach-
ment(s). If bed is raised, place safety support on lift cylin-
der.
3. Make sure that the engine is stopped and the key is
removed from ignition switch. Allow engine to cool.
4. Remove exhaust system components as needed us-
ing Figure 16 as a guide.
5. Discard exhaust gaskets and thoroughly clean
flange surfaces of exhaust manifold and muffler.
Installation (Fig. 16)
1. Replace any removed gaskets.
2. Using Figure 16 as a guide, fit all exhaust compo-
nents to vehicle before tightening any fasteners.
A. If oxygen sensor (item 11) was removed from in-
termediate exhaust pipe, apply antiseize lubricant to
threads of oxygen sensor before installation. Install
and torque sensor from 28 to 36 ft−lb (38 to 48
N−m).
3. Lower or install the cargo bed or other attachment(s).
Gasoline Engine
Kohler
To Next Page
Loading...
