e-STUDIO5520C/6520C/6530C © 2008-2011 TOSHIBA TEC CORPORATION All rights reserved
ADJUSTMENT
3 - 110
(1) Remove 3 screws to take off the transport guide-1 cover from the fuser unit.
Fig. 3-114
(2) Insert the “F/R” side of the separation plate gap confirmation jig into the window closest to you of
the separation plate.
(3) Adjust the gap with the adjustment screw until the 0.5 mm section of the jig is inserted without
touching, but its 0.8 mm section contacts the separation plate.
(4) Insert the “F/R” side of the jig into the window of the separation plate, which is farthest away from
you, and then adjust the gap.
(5) Insert the “C” side of the jig into the window at the center of the separation plate.
(6) Adjust the gap with the adjustment screw until the 0.7 mm section of the jig is inserted without
touching, but its 1.0 mm section contacts the separation plate surface.
Transport guide-2
Transport guide-1 cover
To Next Page
Loading...
