3
© 2008-2011 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO5520C/6520C/6530C
ADJUSTMENT
3 - 111
(7) Repeat step (2) to (6). If you can confirm that all gaps are the correct values, end the procedure.
If the separation plate gap is not adjusted correctly, the problems below may occur.
• If the gap is too large, paper jams may occur frequently when photo images are copied on thin
paper.
• If the gap is too small, stains may appear on the copied image because the separation plate
may scratch the fuser belt.
Fig. 3-115
Separation plate
2
3
1
Separation plate gap
onfirmation jig
To Next Page
Loading...
