Toshiba e-STUDIO6520c - Page 414

e-STUDIO5520C/6520C/6530C © 2008-2011 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE and TROUBLESHOOTING
6 - 32
[E140] 2nd drawer misfeeding (paper not reaching the 2nd drawer feed sensor)
1. Open the paper feed cover and check if there is any paper in front of the 2nd drawer feed sensor.
Remove it if there is.
* If the error still occurs, check the following.
2. Is the 2nd drawer feed sensor working? (Perform the input check: 03-[FAX]ON/[1]/[F])
* If it is working properly, proceed to 6. If not, check 3 to 5 below.
3. Check if the connector CN512 on the PFC board is disconnected from the 2nd drawer feed
sensor or the harnesses are open circuited. Correct if any.
4. Replace the 2nd drawer feed sensor.
5. Replace the PFC board.
6. Is the feed motor working? (Perform the output check: 03-121)
* If it is working properly, proceed to 10. If not, check 7 to 9 below.
7. Check if the connector CN512 on the PFC board is disconnected from the feed motor or the
harnesses are open circuited. Correct if any.
8. Replace the feed motor.
9. Replace the PFC board.
10.Check the 2nd drawer feed roller, separation roller and pickup roller. Replace them if they are
worn out.
[E150] 3rd drawer misfeeding (paper not reaching the 3rd drawer feed sensor)
1. Open the paper feed cover and check if there is any paper in front of the 3rd drawer feed sensor.
Remove it if there is.
* If the error still occurs, check the following.
2. Is the 3rd drawer feed sensor working? (Perform the input check: 03-[FAX]OFF/[2]/[D])
* If it is working properly, proceed to 7. If not, check 3 to 6 below.
3. Check if the connector CN505 on the PFC board is disconnected from the 3rd drawer feed
sensor or the harnesses is open circuited. Check if the connector CN505 on the PFC board is
disconnected. Correct if any.
4. Replace the 3rd drawer feed sensor.
5. Replace the PFC board.
6. Is the feed/transfer motor working? (Perform the output check: 03-226)
* If it is working properly, proceed to 12. If not, check 8 to 11 below.
7. Check if the connectors CN502 on the LGC board is disconnected from the feed/transfer motor
or the harnesses are open circuited. Check if the connector CN502 on the PFC board is
disconnected. Correct if any.
8. Replace the feed/transfer motor.
9. Replace the PFC board.
10.Check the 3rd drawer feed roller, separation roller and pickup roller. Replace them if they are
worn out.