Toshiba e-STUDIO6520c - Page 438

e-STUDIO5520C/6520C/6530C © 2008-2011 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE and TROUBLESHOOTING
6 - 56
[EA21] Paper size error jam
MJ-1103/1104
1. Check if there is any paper in the finisher or on the transport path of the equipment and remove it
if there is.
2. Is the paper size used shorter than the size specified in the specifications?
3. Check if the connectors CN7 and CN22 on the finisher controller PC board are disconnected
from the inlet sensor (S1) and the transport sensor (S2), or the harnesses are open circuited.
Correct if any.
4. Reinstall the sensor correctly if there is any incorrect installation.
5. Replace the sensor.
6. Replace the finisher controller PC board.
[EA22] Short length paper jam in Finisher (paper position sensors S6-1/2)
Is there any paper remaining on the transport path?
È
ÆYES Remove the paper, not leaving any chips.
NO
Is the paper too short for specifications?
È
ÆYES Use paper accepted in the specifications.
NO
Are the paper position sensor (S6-1 and S6-2) and its wiring correct?
È
ÆNO Replace the sensor. Correct the wiring.
YES
Replace the hole punch control PC board (HP).
[EA23] Paper transport jam in Finisher (transport sensor)
Is there any paper remaining on the transport path in the finisher or equipment?
È
ÆYES Remove the paper.
NO
Is there a disconnection of the connector, incorrect installation or breakage of the transport
sensor (S2)?
l
l
È
ÆYES • Reconnect the connector securely if there is any disconnection.
• Reinstall the sensor correctly if there is any incorrect installation.
• Replace the sensor if there is any breakage.
NO
Replace the finisher control PC board (FIN).