Toshiba e-STUDIO6520c - Page 439

6
© 2008-2011 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO5520C/6520C/6530C
ERROR CODE and TROUBLESHOOTING
6 - 57
[EA24] Paper transport jam in Finisher (entrance sensor? transport sensor)
Is there any paper remaining on the transport path in the finisher or equipment?
È
ÆYES Remove the paper.
NO
Is the paper size used shorter than the size specified in the specifications?
È
ÆYES Use the paper size specified in the specifications.
NO
Is there a disconnection of the connector, incorrect installation or breakage of the entrance
sensor (S1)?
Is there a disconnection of the connector, incorrect installation or breakage of the transport
sensor (S2)?
l
l
È
ÆYES • Reconnect the connector securely if there is any disconnection.
• Reinstall the sensor correctly if there is any incorrect installation.
• Replace the sensor if there is any breakage.
NO
Is the harness between the entrance motor (M1) and the CN26 of the finisher control PC board
(FIN) disconnected or open circuited?
Is the harness between the transport sensor (S2) and the CN6 of the finisher control PC board
(FIN) disconnected or open circuited?
l
È
ÆYES • Reconnect the connector securely if there is any disconnection.
• Replace the harness if open circuited.
NO
Replace the finisher control PC board (FIN).
[EA25] Paper transport jam in Finisher (after paper stack was exited)
Is there any paper remaining on the transport path in the finisher or equipment?
È
ÆYES Remove the paper.
NO
Is there any mechanical problem when the actuator of the finishing tray paper detection sensor
(S12) is moved?
È
ÆYES Fix the mechanism.
NO
Is there a disconnection of the connector, incorrect installation or breakage of the finishing tray
paper detection sensor (S12)?
l
l
È
ÆYES • Reconnect the connector securely if there is any disconnection.
• Reinstall the sensor correctly if there is any incorrect installation.
• Replace the sensor if there is any breakage.
NO
Is the harness between the finishing tray paper detection sensor (S12) and the CN18 of the
finisher control PC board (FIN) disconnected or open circuited?
l
È
ÆYES • Reconnect the connector securely if there is any disconnection.
• Replace the harness if open circuited.
NO
Replace the finisher control PC board (FIN).