Toshiba e-STUDIO6520c - Page 440

e-STUDIO5520C/6520C/6530C © 2008-2011 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE and TROUBLESHOOTING
6 - 58
[EA26] Paper transport jam in Finisher (Stop signal received from equipment)
[EA27] Paper transport jam in Finisher (Paper not inserted but paper detected)
Is there any paper remaining on the transport path in the Finisher or the equipment?
È
ÆYES Remove the paper.
NO
Is there a disconnection of the connector, incorrect installation or breakage of the entrance
sensor (S1)?
l
l
È
ÆYES • Reconnect the connector securely if there is any disconnection.
• Reinstall the sensor correctly if there is any incorrect installation.
• Replace the sensor if there is any breakage.
NO
Is the harness between the entrance sensor (S1) and the CN26 of the finisher control PC board
(FIN) disconnected or open circuited?
l
È
ÆYES • Reconnect the connector securely if there is any disconnection.
• Replace the harness if open circuited.
NO
Replace the finisher control PC board (FIN).
[EA28] Paper transport jam in Finisher (paper holding delay)
Is there any paper remaining on the transport path in the finisher or equipment?
È
ÆYES Remove the paper.
NO
Is there any mechanical problem when the paper holding cam is rotated?
È
ÆYES Fix the mechanism.
NO
Is the harness between the assist arm motor (M10) and the CN13 of the finisher control PC
board (FIN) disconnected or open circuited?
l
È
ÆYES • Reconnect the connector securely if there is any disconnection.
• Replace the harness if open circuited.
NO
Replace the finisher control PC board (FIN).
[EA29] Paper transport jam in Finisher (paper stack transport delay)
Is there any paper remaining on the transport path in the Finisher or the equipment?
È
ÆYES Remove the paper.
NO
Is there any mechanical problem when the buffer tray guide is opened and closed while the
buffer roller is kept raised?
È
ÆYES Fix the mechanism.
NO
Is the harness between the buffer tray guide motor (M2) and the CN11 of the finisher control PC
board (FIN) disconnected or open circuited?
l
È
ÆYES • Reconnect the connector securely if there is any disconnection.
• Replace the harness if open circuited.
NO
Replace the finisher control PC board (FIN).