Toshiba e-STUDIO6520c - Page 448

e-STUDIO5520C/6520C/6530C © 2008-2011 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE and TROUBLESHOOTING
6 - 66
[EF10] Selecting paper not supported by Saddle Stitch Finisher
[EF11] Front saddle staple error
Is there any paper remaining on the paper transport path in the Finisher or the equipment, or on
the finishing tray?
È
ÆYES Remove the paper.
NO
Is the jam released by taking off the front staple cartridge from the Finisher and removing the
staple sheet slid from the staple case?
È
ÆYES End.
NO
Is the harness between the front saddle stapler drive unit and the CN3 of the saddle control PC
board (SDL) disconnected or open circuited?
l
È
ÆYES • Reconnect the connector securely.
• Replace the harness if open circuited.
NO
1. Reconnect the connector securely if there is any disconnection.
2. Replace the saddle control PC board (SDL).
[EF12] Rear saddle staple error
Is there any paper remaining on the paper transport path in the Finisher or the equipment, or on
the finishing tray?
È
ÆYES Remove the paper.
NO
Is the jam released by taking off the rear staple cartridge from the Finisher and removing the
staple sheet slid from the staple case?
È
ÆYES End.
NO
Is the harness between the rear saddle stapler drive unit and the CN3 of the saddle control PC
board (SDL) disconnected or open circuited?
l
È
ÆYES • Reconnect the connector securely if there is any disconnection.
• Replace the harness if open circuited.
NO
1. Replace the rear saddle stapler drive unit.
2. Replace the saddle control PC board (SDL).