Toshiba e-STUDIO6520c - Page 449

6
© 2008-2011 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO5520C/6520C/6530C
ERROR CODE and TROUBLESHOOTING
6 - 67
[EF13] Saddle unit paper holding home position detection error
Is there any mechanical problem when the paper holding cam is rotated?
È
ÆYES Fix the mechanism.
NO
Is there a disconnection of the connector, incorrect installation or breakage of the paper holding
home position sensor (S38)?
l
l
È
ÆYES • Reconnect the connector securely if there is any disconnection.
• Reinstall the sensor correctly if there is any incorrect installation.
• Replace the sensor if there is any breakage.
NO
Is the harness between the paper holding home position sensor (S38), paper holding clutch
(CLT4) or saddle transport motor (M16) and the CN8 of the saddle control PC board (SDL)
disconnected or open circuited?
l
È
ÆYES • Reconnect the connector securely if there is any disconnection.
• Replace the harness if open circuited.
NO
Replace the saddle control PC board (SDL).
[EF14] Saddle exit jam
Is there any paper remaining in the paper transport path of the equipment or the saddle stitch
section of the Finisher?
È
ÆYES Remove the paper.
NO
Is there a disconnection of the connector, incorrect installation or breakage of the exit sensor
(S31)?
l
l
È
ÆYES • Reconnect the connector securely if there is any disconnection.
• Reinstall the sensor correctly if there is any incorrect installation.
• Replace the sensor if there is any breakage.
NO
Is the harness between the exit sensor (S31) and the CN19 of the saddle control PC board
(SDL) disconnected or open circuited?
l
È
ÆYES • Reconnect the connector securely if there is any disconnection.
• Replace the harness if open circuited.
NO
Replace the saddle control PC board (SDL).