Toshiba e-STUDIO6520c - Page 483

6
© 2008-2011 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO5520C/6520C/6530C
ERROR CODE and TROUBLESHOOTING
6 - 101
[CC30] Stack transport motor abnormality
[CC31] Transport motor abnormality
[CC41] Paper holder cam home position abnormality
* You receive a [CC30] error when the [EA70] error occurs three times in succession.
MJ-1103/1104
Is there any mechanical problem when the stack transport belt is moved?
È
ÆYES Fix the mechanism.
NO
Is the harness between the stack transport motor (M5) and the finisher control PC board
(CN10) disconnected or open circuited?
l
È
ÆYES • Reconnect the connector securely.
• Replace the harness.
NO
1. Replace the stack transport motor (M5).
2. Replace the finisher control PC board.
* You receive a [CC31] error when the [ED12] error occurs three times in succession.
MJ-1103/1104
Is there any mechanical problem when the stack transport roller -1 and -2 are rotated?
È
ÆYES Fix the mechanism.
NO
Is the harness between the transport motor (M2) and the finisher control PC board (CN5)
disconnected or open circuited?
l
È
ÆYES • Reconnect the connector securely.
• Replace the harness.
NO
1. Replace the transport motor (M2).
2. Replace the finisher control PC board.
MJ-1103/1104
Is there any mechanical problem when the paper holder cam is rotated?
È
ÆYES Fix the mechanism.
NO
Is the harness between the paper holder home position sensor (S6) and the finisher control PC
board (CN17) disconnected or open circuited?
l
È
ÆYES • Reconnect the connector securely.
• Replace the harness.
NO
1. Replace the paper holder home position sensor (S6).
2. Replace the finisher control PC board.