Toshiba e-STUDIO6520c - Page 486

e-STUDIO5520C/6520C/6530C © 2008-2011 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE and TROUBLESHOOTING
6 - 104
[CC80] Rear alignment motor abnormality
[CDE0] Paddle motor abnormality
[CE00] Punch communication error
* You receive a [CC80] error when the [ED14] error occurs three times in succession.
MJ-1103/1104
Is there any mechanical problem when the rear alignment plate is moved?
È
ÆYES Fix the mechanism.
NO
Is the harness between the rear alignment motor (M10) and the finisher control PC board
(CN10) disconnected or open circuited?
l
È
ÆYES • Reconnect the connector securely.
• Replace the harness.
NO
1. Replace the rear alignment motor (M10).
2. Replace the finisher control PC board.
* You receive a [CDE0] error when the [ED15] error occurs three times in succession or during
the initial operation.
MJ-1103/1104
Is there any mechanical problem with the paddle is rotated?
È
ÆYES Fix the mechanism.
NO
Is the harness between the paddle motor (M8) and the finisher control PC board (CN6)
disconnected or open circuited?
l
È
ÆYES • Reconnect the connector securely.
• Replace the harness.
NO
1. Replace the paddle motor (M8).
2. Replace the finisher control PC board.
MJ-1103/1104 (When MJ-6102 is installed)
Is the harness between the hole punch control PC board (HP) and the finisher control PC
board disconnected or open circuited?
È
ÆYES Replace the harness. Correct the wiring.
NO
Is the conductor pattern on the hole punch control PC board (HP) open circuited or short
circuited?
È
ÆYES Replace the hole punch control PC board (HP).
NO
Replace the finisher control PC board.