6
© 2008-2011 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO5520C/6520C/6530C
ERROR CODE and TROUBLESHOOTING
6 - 103
[CC60] Punch motor abnormality
[CC61] Punch motor (M3) home position detection error
MJ-1103/1104 (when MJ-6102 is installed)
Are the punch home position sensor (PI63) and punch motor clock sensor (PI62) working
normally?
È NO Æ Replace the sensors.
YES
Is the wiring between the sensors and finisher controller PC board correct?
È NO Æ Correct the wiring.
YES
Is the punching mechanism normal?
È NO Æ Fix the mechanism.
YES
1. Replace the punch motor (M61).
2. Replace the punch controller PC board.
3. Replace the finisher controller PC board.
* The [CC61] error will be displays when the [E9F0] error occurs three times in succession or
during the initial operation.
MJ-1103/1104 (When MJ-6102 is installed)
Is there any paper remaining on the transport path?
È
ÆYES Remove the paper.
NO
Rotate the punch motor (M3). Does it rotate smoothly?
È
ÆNO Fix the mechanism.
YES
Are the punch home position sensor (S4) and its wiring correct?
È
ÆNO Replace the sensor. Correct the wiring.
YES
Is the wiring between the hole punch control PC board (HP) and punch motor (M3) correct?
È
ÆNO Correct the wiring.
YES
1. Replace the punch motor (M3).
2. Replace the hole punch control PC board (HP).
[CC71] Punch ROM checksum error
[CC72] Punch RAM read/write error
[CC73] Punching device power supply abnormality
[CC74] Transport pulse abnormality
[CE00] Punch communication error
Download the latest version of the PNC board (HP) firmware again and then check its
operation.
È
NO
Replace the hole punch control PC board (HP).
To Next Page
Loading...
